Follow us

Corrections: Take A Stand (PBA273)

Take A Stand (PBA273)

January 30, 2024

On patterns dated before 013024 (see date in middle at bottom of each page), please make these corrections:

​The section that describes the zipper sizes needed should read as follows:

​For the small (large) bag, you will need 48" (62") of zipper tape and 3 (3) pulls to make:

​Bag closure: 18" (22") single-slide zipper

​Exterior pockets: Two 15" (20") single-slide


September 10, 2023

On patterns dated before 091023 (see date in middle at bottom of each page), please make this correction:

​Page 2, Step 1-A.:

​Change the instructions for Using Directional Fabrics as follows:

​҂USING DIRECTIONAL FABRICS: If main/lining fabric is directional, instead cut two 13½” x 16” (18” x 19”) pieces for Quilted Set A Main/Lining. With right sides together, position the two pieces so that the “bottoms” of the design are together on one 16” (19”) side. Sew together along that side with ½" seam; press seam open. Proceed as directed.


June 08, 2020

On patterns dated before 060820 (see date in middle at bottom of each page), please make this correction:

​Page 4, Step II.D.1.c.:

​The Pocket A Border on the small is 2½" x 12" (not 2½" x 12 ½ "). Please change the text as follows:

​c. With right side down, position the bottom 12" (16") side of the prepared 2½" x 12" (3½" x 16") Pocket A Border below the marked line.


October 17, 2018

On patterns dated before 101718 (see date in middle at bottom of each page), please make these corrections:

​Page 3, Step B:

​Prepare the Carrying Strap Tabs and Carrying Strap. On part 4c (Prepare the Carrying Strap Tabs), for the LARGE size only, mark the horizontal line 9 1/4" up from the bottom.

​Page 5, Step B:

​Attach Carrying Strap Tabs. On part 1, for the LARGE size only, you will stitch along the previous line of stitching to the line marked 9 1/4" up from the bottom.

​Page 6, Step E:

​Attach Ends and Bind. On step 1, the end of the last sentence was omitted. It should read, "flip the piece over so that the lining side is up."

​Page 7, Step F:

​Attach Zipper. On part 7b, note that the measurement of the folded Zipper Binding will be 1” x 63”.


January 17, 2022

On patterns dated before 011722 (see date in middle at bottom of each page), please make these corrections:

​Page 5, Step III-C-3:

​In order to create two equal sections in Pocket C, please change the first sentence to read as follows:

​3. Create a division in Pocket C by marking a vertical line from the top bound edge of the pocket to the bottom bound edge 6" (8") in from the left and stitching along the marked line.

​Page 6, Step III-E-1:

​Part of the text in step 1 is covered by figure 19. Please change the first sentence to read as follows:

​1. Flip the piece over so that the lining side is up.




Contact Us

If you need any help with this pattern, please use our contact us page to get in touch with our sewing and customer service team.

We strive to respond to all requests within one business day.

Courses & Tutorials

Please also check our courses and tutorials for 24 hour support.

These videos bring Annie and the team right to your home.